Automatic Setting: Select All - Omron SYSMAC CS1W-CLK13 Operation Manual

Setting Data Links
Data Link Tables
5-2-4

Automatic Setting: Select All

Note
Data links can be automatically created by setting values in the DM parameter
area of the PLC's CPU Unit of the startup node. The settings are made using
a Programming Console or the CX-Programmer.
The startup node is the node from which the data links are activated. When
automatically setting data links, data link operation is based on the values set
in the startup node.
Programming Console
IBM PC/AT or
compatible
Data links can be started using one of the following (See p 127.)
• Using a software switch
• Using the Controller Link Support Software (Ver. 2.00 or higher) or the
CX-Programmer's CX-Net utility
• Using FINS commands
Startup node
Or
CX-Programmer
Section 5-2
CPU Unit
Controller Link
Software switches
(DM area)
107