Remote Programming And Monitoring; Within The Same Network - Omron SYSMAC CS1W-CLK13 Operation Manual

Remote Programming and Monitoring

7-2 Remote Programming and Monitoring
7-2-1

Within the Same Network

SYSMAC Support Software and CV Support Software
SYSMAC Support
Software (CVM1 only)
or
CV Support Software
CX-Programmer
CX-Programmer
188
A remote PLC can be programmed and monitored across a network from a
Programming Device connected to a PLC.
A Programming Device connected to a CVM1, or CV-series CPU Unit can
program and monitor a CVM1, or CV-series PLC on the same network. Pro-
gramming and monitoring are possible, however, only for the same type of
CPU Unit as the one to which the Programming Device is connected. For
example, if the Programming Device is connected to a CVM1 or CV-series
PLC, you can only program and monitor CVM1 or CV-series PLCs on the net-
work.
Programming Device
Controller Link Network (Token-ring)
CVM1 or CV-series PLC
Note
Remote programming and monitoring is not possible from a personal comput-
er used as a node. Computer nodes can only monitor Controller Link Network
status.
Controller Link
Support Software
(Ver. 2.00)
A CX-Programmer connected to a CS-series, C200HX/HG/HE, CVM1, CV-
series, or CQM1H CPU Unit can program and monitor a CPU Unit on the
same network. Programming and monitoring are possible, including CPU
Units that are different to the one to which the Programming Device is con-
nected.
Programming Device
CS-series, CVM1,
or CV-series PLC
Controller Link Network (Token-bus)
Note 1. With CX-Programmer, remote programming and monitoring are possible from a
personal computer used as a node.
2. C200HX/HG/HE PLCs can only be used in token-bus mode (wired).
CVM1 or CV-series PLC
Controller Link Network (Token-bus)
Controller Link Network (Token-ring)
CS-series, CVM1,
or CV-series PLC
CS-series, CVM1, CV-series, or C200HX/HG/HE PLC
Section 7-2
Programming
and monitoring
Programming
and monitoring
Programming
and monitoring