Omron SYSMAC CS1W-CLK13 Operation Manual page 94

Optical Wiring
2. Attach the clamp to the mounting bracket so that it clamps the cable(s).
Two cables can be attached at the same time.
3. Remove the Optical Connector Covers from the Unit's connectors shown
in the following diagram if there are covers protecting the connectors.
Remove the covers from the tips of the cables' ST connectors if there are
covers protecting the ST connectors.
Optical Connector Cover
Rotate the cover 90°
counterclockwise.
Note To replace the Optical Connector Cover, just reverse the steps
shown in the diagram above.
4. Turn the cable connector so that the tab in the connector faces left and
aligns with the slot in the Unit's connector. Insert the cable connector fully
into the Unit's optical connector. Press and turn the cable's connector
clockwise to lock the connector in place.
1. Screw the mounting
bracket to the Unit.
Mounting bracket
2. Attach the clamp to the
mounting bracket so that
the cable(s) are clamped.
Clamp
Pull off the cover.
Section 3-3
71