Omron SYSMAC CS1W-CLK13 Operation Manual page 288

Error Log
Error Contents
code
0115 Transmission failed; redundant
Hex I/O allocations
0116 Transmission failed; CPU Bus
Hex Unit error
0117 Internal buffer full
Hex
0118 Illegal packet discarded
Hex
0203 EEPROM error
Hex
0206 Number of participating nodes
Hex decreased (local node still partic-
ipating)
0207 Number of participating nodes
Hex decreased (local node not partic-
ipating)
0208 Polling node changed
Hex
0209 Inconsistent network parameter
Hex
020C Time out with token
Hex
0210 Communications controller send
Hex error
0211 Duplicate address error
Hex
0214 Node address setting error
Hex
Detail code
1st byte 2nd byte
Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network
address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node
address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
01 Hex: 01 Hex:
Read error Data link
02: Hex: tables
Write error 02 Hex: Net-
work param-
eters
03 Hex:
Routing
tables
Network Number of
parameters non-partici-
maximum pating nodes
node
address
Address of Address of
previous new polling
polling node node
00 Hex Address of
polling node
00 Hex Error status
(See note 3.)
00 Hex Error status
(See note 3.)
00 Hex Local node
address
Not specified
Correction Written to
EEPROM
Check unit numbers No
for redundancy
within the same PLC.
Check Unit and cable No
connections and
clear error.
Increase number of No
retries or reconfig-
ure system to distrib-
ute load.
Check for nodes Yes
sending illegal pack-
ets.
For CVM1 and CV- Yes
series PLCs, check
that the PLC is not
protected.
Remake and set the
relevant data. If the
error occurs again for
the CVM1 and CV-
series, replace the
CPU Unit.
Check network No
parameters, node (See note
participation, cables, 4.)
and terminating
No
resistance.
(See note
4.)
Check previous poll- No
ing node. (See note
4.)
Using the Controller Yes
Link Support Soft-
ware, check network
parameters.
Check network No
parameters, node
participation, cables,
and terminating
resistance.
Replace the Control- Yes
ler Link Unit.
Reset so that each No
node address is (See note
used only once 4.)
within the same Net-
work.
Check the node Yes
address settings and
correct them.
Section 10-3
Applicable
PLC
CV, CS
CV, CS
CV, CS
CV, CS
CV
CV, CS
CV, CS
CV, CS
CV, CS
CV, CS
CV, CS
CV, CS
CS
265