Omron SYSMAC CS1W-CLK13 Operation Manual page 365

Revision History
Revision Date Revised content
code
03 September Changes were made throughout the manual, including the addition of a new section (Section 8), to provide
2002 information on new "-V1" models. This mainly consists of information relating to duplex operation and online
replacement as well as information on version 3 of the CX-Programmer. "PC" was changed to "PLC" (to indi-
cate "Programmable Controller") throughout the manual and "CS1" was changed to "CS" or omitted where
appropriate. In addition, the following changes were made. Appendices A and B were interchanged.
Pages 28 to 31: Changes made to the "Nodes" column in the tables.
Page 32: Table added and order changed (in addition to changes mentioned above).
Page 46: Parenthetic information on CS-series Units added in two places.
Page 48: Wording changed to include "CS1-H" in two places.
Page 58: Note 1 removed.
Pages 59 and 63: Change made to Note 4.
Page 64: Change made to information on setting the transmission path format.
Page 65: Information on creating I/O tables added.
Pages 75, 76: Changes made to information on first data link status word.
Page 76: Number of EM Area banks changed from 15 to 12 in one place.
Page 86: First note removed.
Page 97: Information added to note. Changes made to second table.
Page 99: Note added.
Pages 102, 103, 104, 105, 106, 169, 190: Changes made to graphics.
Page 112: Note removed.
Pages 113, 114: Changes made to tables in several places.
Page 115: Changes made to first paragraph.
Page 116: Line added under grid.
Page 118: 120000 changed to 121000 in one place.
Page 119: XFER changed to @XFER.
Page 120: 00010 changed to 00004 in one place.
Page 124: Change made to information on version.
Page 125: Changes made to bottom graphic.
Page 127: 32 changed to 62 in one place.
Page 128: Changes made to information on data link status read.
Page 129: Information added under graphic.
Page 130: 1 changed to 0 in one place.
Page 140: Information added to "Probable cause" column.
Page 141: "active" changed to "inactive" in one place.
Page 143: Changes made to information in "Probable cause" and "Remedy" columns.
Page 147: Information on CQM1H-series PLCs removed.
Page 149: Changes made to first graphic.
Page 155: # changed to 3 in one place.
Page 162: Change made to information on specifying network parameters and note added.
Page 163: Change made to transmission speed.
Page 169: Changes made to calculations.
Page 170: 7 changed to 1 in one place.
Page 173: 62 changed to 32 in one place.
Pages 192, 198: 1 and 2 interchanged in one place.
Page 195: Information on power supply status removed.
Page 205: Changes made to "Correction" column.
Page 207: Change made to "Contents" and "1st byte" column.
Page 215: Parenthetic information on support software changed in three places.
Page 229: Information on CX-Programmer changed.
Page 230: Connector model number changed in one place.
Page 231: Assembly tool model numbers changed in four places.
Page 233: Information added to table.
Page 243: Changes made to second graphic.
342