Omron SYSMAC CS1W-CLK13 Operation Manual page 64

Data Links Procedures
Note
1:N Allocations
For pre-Ver. 1.2 CS1W-CLK13, CS1W-CLK12-V1, CS1W-CLK53, or
CS1W-CLK52-V1
0306@@_@@@@ or later support 1:N allocations.
Lot Number notation: The first two digits refer to the year (last two digits of
• Common Type
Contents
Set the data link mode to
manual or automatic.
Set the type of 1:N alloca-
tions
Area • Set the area
1
• Set the data link
start word
• Set the number of
send words for the
master node.
• Set the number of
send words
slave node.
Area • Set the area
2
• Set the data link
start word
• Set the number of
send words for the
master node.
• Set the number of
send words
slave node.
Set the first data link status
word
Set the nodes to participate
in the data links.
Use the CX-Net in CX-Programmer version 3.2 or later to automatically set
data links with 1:N allocations.
Controller Link Units,
years from 2000 onwards), and the following two
digits indicate the month (01 to 12, for January to
December, respectively). (The last 7 digits are not
relevant.)
Method
Use a Programming
Device for the PLC,
including Program-
ming Console. (See
note.)
per
per
Section 2-1
units from lot number
Nodes Page
Data link startup node 94
only
Note The node that is
used to start the
data links is
called the star-
tup node. The
node to be used
as the startup
node must be
determined
before data links
can be started.
Data link startup node 113
only
Data link startup node
only
Note: Only when Area
1 is used
Data link startup node
only
Note: Only when Area
2 is used
Data link startup node
only
41