Table of Contents
Advertisement
FPGA CONFIG Menu
The system controller CONFIG menu is used to configure the VCU1287 UltraScale FPGA
from an SD card (callout 8). One of sixteen bitstreams can be selected for use by the
configuration engine by setting a binary encoded value on the system controller mode DIP
switch SW13 (see
when the system controller POR pushbutton (SW4) is pressed. The system controller
CONFIG menu can also be used to select the SD card bitstream.
CONFIG Menu Options
VCU1287 System Controller v1.0
- CONFIG Menu -
-----------------------------
1. Configure UltraScale FPGA from SD Card
0. Return to Main Menu
Option 1: Configure UltraScale FPGA from SD Card
Enter a Bitstream number (0-15):
0
Info : xilinx.sys opened
Info : Opening rev_1/set0/config.def
Info : Configuration definition file "rev_1/set0/config.def" opened
Info : Clock divider is set to 2
Info : Configuration clock frequency is 25MHz
Info : Bitfile "rev_1/set0/vu095led.bit" opened
...10%...20%...30%...40%...50%...60%...70%...80%...90%...100%
Configuration completed successfully
Option 0: Return to Main Menu
This option returns to the menu level above.
VCU1287 Characterization Board
UG1121 (v1.0) December 11, 2015
System Controller Configuration DIP
www.xilinx.com
Appendix D: System Controller
Switches) prior to board power up or
Send Feedback
95
Advertisement
Table of Contents
