Xilinx VCU1287 User Manual page 17

Table 3-2: FPGA Logic and MGT Transceiver Rails (Cont'd)
GTY Transceiver
Notes:
1. The MGT power module must be removed before providing external power to any of
the transceiver rails (see
Monitoring Voltage and Current
Voltage and current monitoring and control for Maxim power system is available through
either the VCU1287 board system controller or the MaximPower Tool software GUI. The
VCU1287 board system controller is the most convenient way to monitor the voltage and
current values for the power rails listed in
feature, see Power Monitoring Data Menu
The VCU1287 board includes these PMBus connectors:
• J21 (callout 20, Figure 1-2), for use with the Maxim USB-to-PMBus interface dongle
(MAXPOWERTOOL002
• J4 (callout 21, Figure 1-2) is used to connect to the MGT power module PMBus using
the Maxim USB-to-PMBus interface dongle (MAXPOWERTOOL002
InTune Digital Power GUI.
Use wires to connect the J4 pins to the Maxim MAXPOWERTOOL002 dongle as shown in
Note:
Figure 3-2.
VCU1287 Characterization Board
UG1121 (v1.0) December 11, 2015
Power Rail Net External Supply
Name Connector (s)
MGTAVCC_L
MGTAVTT_L J67
MGTVCCAUX_L
FPGA Configuration).
[Ref 5]) and the InTune Digital Power GUI.
www.xilinx.com
Chapter 3: Board Component Descriptions
Power Regulation
Jumper
J62
J63
J64
Table 3-2. For details on how to use this built-in
in Appendix D, System Controller.
[Ref 5]) and the
Send Feedback
17