Xilinx VCU1287 User Manual page 11

Table 2-1: VCU1287 Board Components (Cont'd)
Callout Reference Designator
21
22
23
24
25
DS19, DS20, DS21,
26 DS22, DS23, DS24,
27
28
29
30
31
32
33
34 J13, J14, J84, J85
35
36
37 DS1, DS12, DS16, DS27 System controller status LEDs
SW5, SW6, SW10,
38
39
40
Default Jumper and Switch Positions
A list of jumpers and switches and their required positions for normal board operation is
provided in Appendix A, Default Jumper
VCU1287 Characterization Board
UG1121 (v1.0) December 11, 2015
Bank 224-233 GTH transceiver power supply module
jumpers and switches and their required positions for normal
J46, J124
board operation is provided in Appendix A, Default Jumper
Settings.)
FPGA and utility rails PMBUS connector
J21 switches and their required positions for normal board
operation is provided in Appendix A, Default Jumper
MGT rails PMBus connector
J4 their required positions for normal board operation is provided
in Appendix A, Default Jumper
J1 Connector for
J99 Active Heat Sink Power Connector
User LEDs (Active-High)
DS25, DS26
SW8, SW9 User Pushbuttons (Active-High)
SW3 User DIP Switches (Active-High) and I/O Header
J95 User DIP Switches (Active-High) and I/O Header
JA2 FMC1 connector
JA3 FMC2 connector
JA4 FMC3 connector
J73 ATX power connector
Differential SMA MRCC Pin Inputs
U38 System controller
J3 System controller JTAG connector
System controller GPIO pushbuttons
SW11, SW12
J6 JTAG chain select
DS2 PowerGood LED
www.xilinx.com
Chapter 2:
Feature Description
(A list of jumpers and switches and
Settings.)
USB to Dual UART Bridge
(I2C Bus Management)
(I2C Bus Management)
(I2C Bus Management)
(12V Input Power)
Settings.
Board Setup and Configuration
(A list of
(A list of jumpers and
Settings.)
(mini-B receptacle)
Send Feedback
11