Appendix 1. Program Parameter Input N No. Correspondence Table - Mitsubishi Electric MELDAS C6 Programming Manual

Appendix 1. Program Parameter Input N No. Correspondence Table

Appendix 1. Program Parameter Input N No. Correspondence Table
(Note 1) The units in the table indicate the minimum setting units for the parameter data.
(Note 2) The setting ranges given in the table are the setting ranges on the screen. Designate
(Note 3) The binary type parameters must be converted into byte-type data, and commanded
P No. 2 (Axis independent parameter)
Parameter
No.
#8201 Axis bit parameter 2
#8202 Axis bit parameter 1
#8204
Soft limit (−)
(User stroke end lower
limit)
#8205 Soft limit (+)
(User stroke end upper
limit)
#8206 Tool change
parameters related to the length by doubling the input setting unit. However, the
parameters with " " in "etc" column (ZERO-RTN PARAM 2027, 2028, 2029) must be
excluded.
(Example 1) To set 30mm in a parameter when the input setup unit is B (0.001mm) and
metric system.
L60000
(Example 2) To set 5 inch in a parameter when the input setup unit is B (0.0001 inch)
and inch system.
L100000
with a decimal data after address D.
(Example 1) Binary data
01010101
(Example 2) ASCII code
"M" = 01001101
(B indicates Binary, H indicates Hexadecimal, and D indicates Decimal.)
Details N No.
896
897
916
912
924
= 55 = 85 ....................... Command 85
B H D
= 4D = 77 ............. Command 77
B H D
Data
Setting range
type
Bit Same as above
Bit d0 : No. d bit
OFF
or
d1 : No. d bit ON
(d : 0 ~ 7)
2-word ± 99999999 × 2 Interpolation
2-word ± 99999999 × 2 Interpolation
2-word ± 99999999 × 2 Interpolation
318
(Unit) Remarks
bit0 :
bit1 :
bit2 :
bit3 :
bit4 :
bit5 :
bit6 : Axis
removal
bit7 :
bit0 :
bit1 :
bit2 : Soft limit
invalid
bit3 :
bit4 :
bit5 :
bit6 :
bit7 :
unit
unit
unit