Mitsubishi Electric MELDAS C6 Programming Manual page 74

7. Feed Functions
Application example
(1) Line − line corner
The override set in the parameter is applied at Ci.
(2) Line − arc (outside) corner
The override set in the parameter is applied at Ci.
(3) Arc (inside offset) − line corner
The override set in the parameter is applied at Ci.
( Note) The deceleration range Ci where the override is applied is the length of the arc with an
arc command.
(4) Arc (inside offset) − arc (outside offset) corner
The override set in the parameter is applied at Ci.
7.10 Automatic corner override
θ
Ci
Tool
θ
Ci
Tool
Program
Tool center
Tool
θ
N1
Ci
66
Program
Tool center
Tool center
Program
θ
Ci
Tool
N2
Program
Tool center