Mitsubishi Electric MELDAS C6 Programming Manual page 23

3. Data Formats
G code
82
83
84
85
86
87
88
89
∆
90
* 91
92
93
* 94
∆
95
∆
96
* 97
* 98
99
113
114.1
115
116
117
100 ~ 255
(Note 1) A (∗) symbol indicates the G code to be selected in each group when the power is turned
ON or when a reset is executed to initialize the modal.
∆
(Note 2) A (
initialization status when the power is turned ON or when a reset is executed to initialize
the modal. Note that inch/metric changeover can only be selected when the power is
turned ON.
(Note 3) A (•) symbol indicates a function dedicated for multi-part system.
(Note 4) If two or more G codes from the same group are commanded, the last G code will be
valid.
(Note 5) This G code list is a list of conventional G codes. Depending on the machine, movements
that differ from the conventional G commands may be included when called by the G code
macro. Refer to the Instruction Manual issued by the machine manufacturer.
Group
09
09
09
09
09
09
09
09
03
03
00
05
05
17
17
10
10
00
00
00
00
00
00
) symbol indicates the G code for which parameters selection is possible as an
Fixed cycle (drill/counter boring)
Fixed cycle (deep drilling)
Fixed cycle (tapping)
Fixed cycle (boring)
Fixed cycle (boring)
Fixed cycle (back boring)
Fixed cycle (boring)
Fixed cycle (boring)
Absolute value command
Incremental command value
Machine coordinate system setting
Asynchronous feed (per-minute feed)
Synchronous feed (per-revolution feed)
Constant surface speed control ON
Constant surface speed control OFF
Fixed cycle Initial level return
Fixed cycle R point level return
Spindle synchronous control OFF
Spindle synchronous control ON
•
Start point designation synchronization (type1)
•
Start point designation synchronization (type2)
•
Miscellaneous function output during axis movement
User macro (G code call) Max. 10
15
3.8 G code lists
Function