Mitsubishi Electric MELDAS C6 Programming Manual page 283

13. Program Support Functions
(9) The two other part systems start when the G116 command is issued for 3 part systems.
Own part system
Other part system A
Other part system B
(10) The single block stop function does not apply for the G116 block.
(11) When the G116 command is issued continuously in 2 or more blocks, the block in which it was
issued last will be valid.
(12) A program error (P32) will occur if an address other than an axis is designated in G116
command block.
13.15 Start Point Designation Synchronizing (Type 2)
!2!3 L1 G116
275
!1!3 L1
!1!2 L1