12. Tool Offset Functions
12.4 Programmed offset input; G10, G11
Function and purpose
The tool offset and workpiece offset can be set or changed on the tape using the G10 command.
During the absolute value (G90) mode, the commanded offset amount will become the new offset
amount, and during the incremental value (G91) mode, the commanded offset amount will be
added to the currently set offset amount to create the new offset amount.
Command format
(1) Workpiece offset input
G90 G10 L2 P__Xp__Yp__Zp__;
G91
P
(Note)
(2) Tool offset input
(a) For tool offset memory I
G10 L10 P__R__ ;
P
R
(b) For tool offset memory II
G10 L10 P__R__ ;
G10 L11 P__R__ ;
G10 L12 P__R__ ;
G10 L13 P__R__ ;
(3) Offset input cancel
G11 ;
: 0 External workpiece
1 G54
2 G55
3 G56
4 G57
5 G58
6 G59
If a value other than the above is set or if the P command is omitted,
the currently selected workpiece offset will be handled as the input.
The offset amount in the G91 will be an incremental value and will be cumulated
each time the program is executed. Command G90 or G91 before the G10 as a
cautionary means to prevent this type of error.
: Offset No.
: Offset amount
12.4 Programmed offset input
Tool length compensation shape offset
Tool length compensation wear compensation
Tool radius shape offset
Tool radius wear compensation
144