Mitsubishi Electric MELDAS C6 Programming Manual page 250

13. Program Support Functions
Example of program
(Example 1) G12 I5000 D01 F100 ; (Input setting unit 0.01)
When offset amount is +10.00mm
Cautions
(1) If the offset No. "D" is not issued or if the offset No. is illegal, the program error (P170) will
occur.
(2) If [Radius (I) = offset amount] is 0 or negative, the program error (P233) will occur.
(3) If G12 or G13 is commanded during diameter compensation (G41, G42), the diameter
compensation will be validated on the path after compensating with the D commanded with
G12 or G13.
(4) If an address, not included in the format, is commanded in the same block as G12 and G13, a
program error (P32) will occur.
242
13.8 Circle cutting
Y
Tool
Offset
10.000m
50.000m Radius
X