Mitsubishi Electric MELDAS C6 Programming Manual page 76

7. Feed Functions
Precautions
(1) Automatic corner override is valid only in the G01, G02, and G03 modes; it is not effective in
the G00 mode. When switching from the G00 mode to the G01 (or G02 or G03) mode at a
corner (or vice versa), automatic corner override will not be applied at that corner in the G00
block.
(2) Even if the automatic corner override mode is entered, the automatic corner override will not
be applied until the tool diameter compensation mode is entered.
(3) Automatic corner override will not be applied on a corner where the tool radius compensation
is started or canceled.
Start-up block
(4) Automatic corner override will not be applied on a corner where the tool radius compensation
I, J vector command is issued.
Block containing
I, J vector command
(G41X_Y_I_J_;)
(5) Automatic corner override will not be applied when intersection calculation cannot be
executed.
Intersection calculation cannot be executed in the following case.
(a) When the movement command block does not continue for four or more times.
(6) The deceleration range with an arc command is the length of the arc.
(7) The inside corner angle, as set by parameter, is the angle on the programmed path.
(8) Automatic corner override will not be applied when the maximum angle in the parameter is set
to 0 or 180.
(9) Automatic corner override will not be applied when the override in the parameter is set to 0 or
100.
7.10 Automatic corner override
Program
Tool center
Automatic corner override will not be applied
Automatic corner override
will not be applied
68
Cancel
block
Program
Tool center