Mitsubishi Electric MELDAS C6 Programming Manual page 177

13. Program Support Functions
Line at angle (G35)
G35 X x1 Y y1 I d J θ K n ;
X, Y :Designation of start point coordinates. This will be affected by G90/G91.
I :Interval d. The unit follows the input setting unit. If d is negative, the drilling will
take place in the direction symmetrical to the point that is the center of the start
point.
:Angle θ . The CCW direction is positive.
J
(The decimal point position will be the degree class. If there is no decimal point,
the unit will be 0.001 ° .)
K :No. of holes n to be drilled. 1 to 9999 can be designated, and the start point is
included.
Using the position designated by X and Y as the start point, the Zn holes will be drilled with interval
d in the direction created by X axis and angle θ . The hole drilling operation at each hole position will
be determined by the standard canned cycle, so the hole drilling data (hole machining mode and
hole machining data) must be held beforehand. The movement between hole positions will all be
done in the G00 mode. G35 will not hold the data even when the command is completed.
(Example)
When input setting unit is 0.001mm
(Note 1) If the K command is K0 or if there is no K command, the program error (P221)
(Note 2) If the K value is more than four digits, the last four digits will be valid.
(Note 3) If a group 0 G command is issued in the same block as the G35 command, the
(Note 4) If there is a G72 to G89 command in the same block as the G35 command, the
G91 ;
G81 Z − 10000 R5000 L0 F100 ;
G35 X200000 Y100000 I100000 J30000 K5 ;
y =100mm
1
x
1
Position before
G35 is executed
will occur.
command issued later is the priority.
(Example) G35 G28 Xx
G35 is ignored G 28 is executed as Xx1 Yy1
canned cycle will be ignored, and the G35 command will be executed.
169
13.2 Special canned cycle
d=100mm
=200mm
Yy Ii Jj Kk
1 1 1 1
n = 5 holes
θ
=30 °
;
1