Oil Pressure Inspection [Lf] - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
11. Install the oil pressure switch.
Tightening torque
1217 Nm {1.2-1.8 kgf·m, 9-13 ft·lbf}
12. Install the under cover.
13. Connect the negative battery cable.
14. Install the battery cover. (See
15. Start the engine and inspect for oil leakage.
• If the oil leaks, specify the malfunctioning part and repair or replace it.

OIL PRESSURE INSPECTION [LF]

Warning
• Continuous exposure to used engine oil has caused skin cancer in laboratory mice. Protect your
skin by washing with soap and water immediately after working with engine oil.
• Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the
engine oil have cooled.
1. Remove the battery cover. (See
2. Disconnect the negative battery cable.
3. Remove the under cover.
4. Remove the oil pressure switch.
5. Screw the SST into the oil pressure switch installation hole.
Downloaded from
BATTERY REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
https://carmanualshub.com/
[Z6].)
[LF].)
- automotive repair manuals website
B3E011101003W04