No.3 Engine Mount Removal Note; Engine Front Cover Removal Note - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
4. Hold the crankshaft pulley using the SSTs.

No.3 Engine Mount Removal Note

1. Install the suitable wood slabs between the front fender panel and apron reinforcement upper.
Note
• Wood slab height
4SD: approx. 35 mm {1.38 in}
5HB: approx. 60 mm {2.36 in}
• Cut the wood slab into two piece and insert.
2. Support the engine using the SST.
Note
• A hoist or small crane can be used in place of the SST (49E 017 5A0).

Engine Front Cover Removal Note

1. Remove the oil seal using a screwdriver as shown in the figure.
Downloaded from https://carmanualshub.com/ - automotive repair manuals website