Mazda 3 Workshop Manual page 647

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
(7) Coolant and P/S reserve tank with the hoses and pipes still connected
(8) Generator (See
(9) Water pump (See
(10) Accelerator cable bracket (body side)
(11) Earth (No.3 engine mount)
5. Disconnect the following parts:
(1) Ventilation hose
(2) OCV wiring harness
(3) CKP sensor connector
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
8. Start the engine.
9. Inspect the following and adjust them if necessary.
(1) Amount of engine oil (See
(2) Pulley and belt for runout and contact
(3) Ignition timing and idle speed. Verify the amount of CO and HC. (See
[Z6].)
10. Perform a road test and verify that there is no abnormal vibration or noise.
Downloaded from
GENERATOR REMOVAL/INSTALLATION
WATER PUMP REMOVAL/INSTALLATION
ENGINE OIL LEVEL INSPECTION
https://carmanualshub.com/
[Z6].)
[Z6].)
[Z6].)
ENGINE TUNE-UP
- automotive repair manuals website