Atomization Inspection - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
8. Turn the ignition switch to the ON position.
9. Using the simulation function "FP", start the fuel pump.
10. Measure the fuel injection volume.
• If not within the specification, replace the fuel injector.
Standard
64-84 ml {64-84 cc, 3.9-5.1 cu in}/15 s
11. Turn the ignition switch to the LOCK position and stop the fuel pump.
12. Remove the wire or the equivalent securing the fuel injector.
13. Install the fuel injector. (See
14. Inspect all related parts by performing "AFTER SERVICE PRECAUTION". (See
PRECAUTION.)

Atomization Inspection

1. Inspect the atomization status.
• If not normal, replace the fuel injector.
Downloaded from
FUEL INJECTOR REMOVAL/INSTALLATION
https://carmanualshub.com/
[Z6].)
AFTER SERVICE
- automotive repair manuals website