Engine Removal/Installation [Lf] - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Tightening torque
8.0-11.5 N·m
{81.6-117.2 kgf·cm, 70.9-101.7 in·lbf}

ENGINE REMOVAL/INSTALLATION [LF]

Warning
• Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always
keep sparks and flames away from fuel.
• Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death
and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line
Safety Procedure". (See
1. Remove the plug hole plate (See
2. Remove the air hose and air cleaner component (See
REMOVAL/INSTALLATION
3. Remove the battery cover, battery duct, battery clamp, battery and battery tray (See
REMOVAL/INSTALLATION
4. Disconnect the fuel hose (See
5. Remove the following parts.
(1) Accelerator cable and bracket.
(2) Front wheels and tires (See
(3) Under cover and splash shields.
(4) A/C drive belt (See
(5) A/C compressor with the pipes still connected.
Note
• Secure the A/C compressor using wire or rope so that it is out of the way.
6. Drain the transaxle oil (MTX) (See
7. Drain the engine coolant (See
Downloaded from
Fuel Line Safety Procedure.)
PLUG HOLE PLATE REMOVAL/INSTALLATION
[LF].)
[LF].)
QUICK RELEASE CONNECTOR
GENERAL PROCEDURES
DRIVE BELT REPLACEMENT
TRANSAXLE OIL REPLACEMENT
ENGINE COOLANT
https://carmanualshub.com/
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
(SUSPENSION).)
[LF].)
[F35M-R].)
REPLACEMENT.)
- automotive repair manuals website
B3E011001001W04
[LF].)
BATTERY