Mazda 3 Workshop Manual page 665

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
(8) Select cable and shift cable (MTX) (See
[F35M-R].)
(9) Clutch release cylinder with the pipe still connected (MTX) (See
CYLINDER REMOVAL/INSTALLATION.)
(10) Earth (No.3 engine mount)
(11) The A/C compressor with the pipes still connected.
Note
• Secure the A/C compressor using wire or rope so that it is out of the way.
8. Disconnect the following parts:
(1) Brake vacuum hose
(2) Fuel hose (See
(3) Heater hose
(4) Upper and lower radiator hose
(5) Main silencer (See
9. Remove in the order indicated in the table.
10. Install in the reverse order of removal.
Caution
• Do not tighten the No.1 engine mount rubber installation bolt before installing the No.3 engine
mount. (See No.3 Engine Mount Installation
11. Inspect the following and adjust them if necessary.
• Front wheel alignment (See
• Pulley and belt for runout and contact.
• Leakage of engine oil, engine coolant, ATF, MT oil, and fuel.
• Ignition timing and idle speed. Verify the amount of CO, HC. (See
• Engine-driven accessories operation
Note
• If the engine is overhauled and installed to the vehicle, perform the road test and verify that
there is no abnormality.
Downloaded from
MANUAL TRANSAXLE REMOVAL/INSTALLATION
QUICK RELEASE CONNECTOR
EXHAUST SYSTEM REMOVAL/INSTALLATION
Note.)
FRONT WHEEL
https://carmanualshub.com/
CLUTCH RELEASE
REMOVAL/INSTALLATION.)
ALIGNMENT.)
ENGINE TUNE-UP
- automotive repair manuals website
[Z6].)
[Z6].)