Timing Chain Removal/Installation [Lf] - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
Item
Standard
Minimum
Maximum difference between cylinders 196.1 {2.0, 28.5}
12. Disconnect the compression gauge.
13. Install the following parts.
(1) Spark plug (See
(2) Ignition coils. (See
(3) Fuel pump relay. (See
(4) Plug hole plate (See

TIMING CHAIN REMOVAL/INSTALLATION [LF]

Warning
• Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always
keep sparks and flames away from fuel.
• Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death
and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line
Safety Procedure". (See
1. Remove the following parts.
(1) Plug hole plate (See
(2) Plug hole plate bracket.
(3) Accelerator cable and bracket.
(4) Battery cover (See
2. Disconnect the negative battery cable.
3. Remove the following parts.
(1) Ignition coils. (See
(2) Front wheel and tire (RH). (See
(3) Under cover and splash shields
(4) Crankshaft position (CKP) sensor. (See
REMOVAL/INSTALLATION
(5) Drive belt. (See
Downloaded from
Engine type
LF
1,720 {17.54, 246.8} [300]
1,204 {12.28, 174.6} [300]
SPARK PLUG REMOVAL/INSTALLATION
IGNITION COIL REMOVAL/INSTALLATION
BEFORE SERVICE
PLUG HOLE PLATE REMOVAL/INSTALLATION
Fuel Line Safety Procedure.)
PLUG HOLE PLATE REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
IGNITION COIL REMOVAL/INSTALLATION
GENERAL PROCEDURES
CRANKSHAFT POSITION (CKP) SENSOR
[LF].)
DRIVE BELT REPLACEMENT
https://carmanualshub.com/
[LF].)
[LF].)
PRECAUTION.)
[LF].)
[LF].)
(SUSPENSION).)
[LF].)
- automotive repair manuals website
[LF].)
B3E011012201W01
[LF].)