Dtc P0610 [Lf] - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
VERIFY TROUBLESHOOTING OF DTC P0602
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Turn the ignition switch to the ON position
(Engine off).
3
• Clear the DTC from the PCM memory using
the WDS or equivalent.
• Perform the HO2S heater, HO2S, and TWC
Repair Verification Drive Mode. (See
DRIVE MODE [LF].)
• Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
4
(See AFTER REPAIR PROCEDURE
• Are any DTC present?
DTC P0610
DETECTION CONDITION • PCM data configuration error
POSSIBLE CAUSE
Diagnostic procedure
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
• Has FREEZE FRAME DATA been
recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
• Verify related service repair information
2
availability.
• Is any related repair information
available?
Downloaded from
OBD
[LF].)

DTC P0610 [LF]

PCM vehicle options error
• Configuration procedure has not been completed
• PCM malfunction
Yes Go to the next step.
No
Yes
No Go to the next step.
https://carmanualshub.com/
Replace the PCM, then go to the next
step.
Yes
(See PCM REMOVAL/INSTALLATION
[LF].)
No Go to the next step.
Go to the applicable DTC troubleshooting.
Yes
(See DTC TABLE [LF].)
No Troubleshooting completed.
ACTION
Record the FREEZE FRAME DATA on the repair
order, then go to the next step.
Perform repair or diagnosis according to the
available repair information.
• If the vehicle is not repaired, go to the next
step.
- automotive repair manuals website
B3E010201088W02