Figure 11-1 Adsl Port Setup; Table 11-2 Adsl Port Setup - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
The following table describes this screen.
LABEL
Profile Setup Click this link to go to a screen for setting up DSL profiles.
Port Number This field shows "0" for the Ethernet port.
Active This field shows whether or not this port is enabled (the Ethernet port is always enabled).
Name This field displays the port's descriptive name if one has been configured.
Auto-Neg This field shows whether auto-negotiation is turned on (Yes) or not (No). The Speed and
Duplex fields display N/A when the auto-negotiation is turned on.
Speed This is the speed of the Ethernet connection.
Duplex The duplex mode can be half (meaning traffic is transmitted in one direction at a time) or full
(meaning traffic is simultaneously transmitted in both directions).
Port Number This field identifies the port's index number.
Active This field shows whether the port is turned on (Yes) or not (No). The factory default of all ADSL
ports is disabled. A port must be enabled for data transmission to occur.
Profile This field shows which profile is assigned to this port.
Mode This field shows to which ADSL operational mode the port is set.
UpStream
This field shows the maximum upstream speed that is configured for this port.
Rate (Kbps)
DownStream
This field shows the maximum downstream speed that is configured for this port.
Rate (Kbps)
Channels This field displays the number of PVCs (Permanent Virtual Circuits) that are configured for this
port.
11-4

Figure 11-1 ADSL Port Setup

Table 11-2 ADSL Port Setup

DESCRIPTION
ADSL Module Port Setup