ZyXEL Communications IES-1000 User Manual page 190

MODULE
ip
arp
config
enable
device
enable
disable
ping
route
routes
stats
subnet
Commands Introduction
Table 22-1 Commands
COMMAND
add <if> <ip> <mac>
delete <if> <ip>
flush
list
help
save
[<if> [mtu <size> [<ip>
[<ipmask>]]]
[list]
add <if> <type> <file> [mtu
<size>] [<IP> [mask <mask>]]
delete <if>
flush
<if>
<if>
<host> [ttl [size]]
add <routeName> <ip> <relayIp>
[ <mask> [ <cost> [ <timeout>
]]]
delete <routeName>
flush
help
arp [reset]
icmp [reset]
ip [reset]
raw [reset]
tcp [reset]
udp [reset]
add <netName> <if> <ip> <mask>
IES-1000 User's Guide
DESCRIPTION
Adds ARP record <ip> <mac> to
interface <if>.
Deletes ARP record <ip> from
interface <if>.
Flushes all cached ARP records.
Lists all resolved ARP records.
Shows a help message for the ARP
command.
Shows the IP module's run-time
configuration.
Saves the IP module's configuration to
the nonvolatile memory.
Sets the IP address setting of the
specified interface.
Lists interface definitions.
Adds a new interface.
Deletes the specified interface.
Deletes all interfaces.
Enables the specified interface.
Disables the specified interface.
Does a ping test.
Displays all routing entries.
Adds a routing entry.
Deletes a routing entry.
Deletes all routing entries.
Shows all routing entries.
Shows the help information about the
stats command.
Shows or resets the ARP statistics.
Shows or resets the ICMP statistics.
Shows or resets the IP statistics.
Shows or resets the raw statistics.
Shows or resets the TCP statistics.
Shows or resets the UDP statistics.
Creates a subnet.
22-15