Figure 10-12 Bridge Mac Address Record - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
LABEL
Max Static MAC Use this field to limit the number of MAC addresses that may be statically specified for this port.
Count For example, if you are configuring port 2 and you set this field to "5", then only five device
MAC addresses may be statically configured on port 2 at any one time.
The valid range is from "0" to "5". "0" means no MAC addresses may be statically specified for
this port.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000 loses
these changes if it is turned off or loses power, so use the Config Save link on the navigation
panel to the left to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
10.5.5 Bridge MAC Address Record Screen
Click MAC Address Record in the Bridge Setup screen to open this screen.
This screen displays a list of the MAC addresses that have connected to each individual port on the network
module. The listing includes MAC addresses and the connected time (measured in seconds) for each port.
10-12
Table 10-10 MAC Count Filter Edit

Figure 10-12 Bridge MAC Address Record

DESCRIPTION
Getting Started Screens