Snmp Trap Configuration - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
34.3.2 SNMP Access Delete Command
Syntax:
access delete <community> [<IP addr>]
This command revokes SNMP access by the specified community (password). If the IP address is specified,
access is denied for that manager station only.
34.3.3 SNMP Access Flush Command
Syntax:
access flush
This command revokes access by any and all manager stations.
34.3.4 SNMP Access List Command
Syntax:
access list
This command shows the allowed access.
34.4

SNMP Trap Configuration

The network module uses the SNMP trapping facility to proactively report unusual events to one or more trap
servers. To configure the trap parameters, use the trap commands in the SNMP subsystem. After configuring the
SNMP trap parameters, save the configuration to the nonvolatile memory with the config save command.
34.4.1 Trap Add Command
Syntax:
trap add <community> <IP addr>
where
<community>
<IP addr>
This command adds a trap server.
34-2
= The password used by the network module to authenticate itself to the trap
server.
= The IP address of the trap server.
Remote Management