Figure 10-20 Edit 802.1X Setup; Table 10-17 Edit 802.1X Setup - ZyXEL Communications IES-1000 User Manual

IES-1000 User's Guide
LABEL
Shared Secret Specify a password (up to 31 alphanumeric characters) as the key to be shared between the
external RADIUS server and the IES-1000. This key is not sent over the network. This key
must be the same on the external RADIUS server and the IES-1000.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to the left to save your changes to the non-volatile memory when you are
done configuring.
Reset Click Reset to begin configuring this screen afresh.
802.1X Edit Screen
Click 802.1X in the Bridge Setup screen to open the 802.1X Setup screen.
Click a port's index number in the 802.1X Setup screen to edit the port's IEEE 802.1X settings.
LABEL
Bridge Setup Click this link to go to the Bridge Setup screen.
802.1X Setup Click this link to go to the 802.1X Setup screen.
Active Select this checkbox to turn on IEEE 802.1X authentication on this port.
Control Select Auto to authenticate all subscribers before they can access the network through this
port.
Select Force Authorized to allow all connected users to access the network through this
port without authentication.
Select Force Unauthorized to deny all subscribers access to the network through this port.
10-20
Table 10-16 RADIUS Server Setup

Figure 10-20 Edit 802.1X Setup

Table 10-17 Edit 802.1x Setup

DESCRIPTION
DESCRIPTION
Getting Started Screens