ZyXEL Communications IES-1000 User Manual page 165

LOG MESSAGE
ADSL <port> Link
Down(SN=<seq no>)
ADSL <port> Link
Up(SN=<seq no>): <us
rate>/<ds rate>
Insecure SNMP From <ip
addr>
Incorrect SNMP
Password
CONSOLE Session End
CONSOLE Session Begin
FTP Session End
FTP Session Begin
Insecure FTP From <ip
addr>
Collision at
downloading file!
Incorrect FTP Password
Reboot System
Received Image
Checksum Error
Invalid Image
File Size Too Large
Receive <file name> OK
GSHDSL
OVER_HEAT_ACTIVE:
<temp>
GSHDSL
OVER_HEAT_RELEASE:
<temp>
Diagnostic
Table 20-3 Log Messages
TYPE
WARN An ADSL port lost its connection.
<port>
<seq no>
WARN An ADSL port established a connection.
<ds rate>
<us rate>
WARN Someone tried to start an SNMP session from an IP address that did
not match any of the configured secured client IP addresses.
Someone attempted to use the wrong password to start an SNMP
WARN
session.
INFO A console session has terminated.
INFO A console session has started.
INFO An FTP session has terminated.
INFO An FTP session has started.
WARN Someone tried to start an FTP session from the listed IP address and
it did not match any of the configured secured client IP addresses.
WARN Someone attempted to use FTP or the web configurator to upload
firmware but the upload conflicted with another process (maybe
someone else was using another method to upload firmware at the
same moment).
WARN Someone attempted to use the wrong password to start an FTP
session.
WARN The network module is restarting after a firmware upload via FTP or
console port, or due to a command invoked by an administrator.
WARN A checksum error was detected during an attempted FTP firmware
upload.
WARN Someone attempted to use FTP upload a firmware file with a wrong
identity.
WARN The file size was too large with an attempted FTP firmware upload.
WARN A file was uploaded to the network module by FTP.
<file name>
WARN The temperature detected in the G.SHDSL module was too high.
<temp>
WARN The temperature detected in the G.SHDSL module has come back to
normal.
<temp>
DESCRIPTION
- port number
- sequence number of the connection
- downstream rate
- upstream rate
- received file's name
- temperature when the entry was logged
- temperature when the entry was logged
IES-1000 User's Guide
20-3