Figure 12-6 Add G.shdsl N-Wire Group - ZyXEL Communications IES-1000 User Manual

LABEL
Default VLAN Type the Port VLAN ID (PVID) from 1 to 4094. The IES-1000 assigns the PVID to untagged
ID frames or priority frames (0 VID) received on this port.
GVRP GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network. The IES-1000
propagates VLAN information to other devices when this check box is selected.
VLAN Select All if you want the port to accept both tagged and untagged incoming frames (on this
Acceptable port). Choose Tagged if you want the port to accept just tagged incoming frames (on this
Frame Type port).
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link in the
navigation panel on the left to save your changes to the non-volatile memory when you are
done configuring.
Reset Click Reset to begin configuring this screen afresh.
12.8.4 Add G.SHDSL N-wire Group
Click Add in the Port Setup screen (under the n-wire table) to go to the Add G.SHDSL N-wire Group screen.
7
At the time of writing, GVRP is not available with the DSL ports.
8
At the time of writing, the VLAN Acceptable Frame Type field is read-only. The IES-1000 accepts both tagged and
untagged incoming frames.
G.SHDSL Module Port Setup
Table 12-5 G.SHDSL Port Setup
8

Figure 12-6 Add G.SHDSL N-wire Group

DESCRIPTION
IES-1000 User's Guide
7
12-9