ZyXEL Communications IES-1000 User Manual page 183

IES-1000 User's Guide
MODULE
radius
edd
version
test
set timeout
ethernet set
status
save
exit
flashfs
config
default
22-8
Table 22-1 Commands
COMMAND
disable <port>
control <port> <auto|auth|
unauth>
reauth <port> <on|off>
period <port><value>
status <port>
ip <addr>
port <portnum>
secret <secret>
show
<ip>
[<# of minutes>]
auto <on | off>
duplex <full | half>
speed <100 | 10>
<partition>
DESCRIPTION
Disables 802.1X security on the
specified port.
Sets how the specified port should be
authenticated.
Turns re-authentication on or off on
the specified port.
Configures how often the specified
port should be re-authenticated.
Displays 802.1X security status on the
specified port.
Sets the external RADIUS server IP
address.
Sets the external RADIUS server port
number.
Sets the authentication and encryption
key.
Displays the external RADIUS server
settings.
Displays Ethernet device driver
information.
Enables a ping-based Ethernet work
around.
Sets the Ethernet test timeout value.
Enables/disables Ethernet port auto
negotiation.
Sets the Ethernet port to full or half
duplex.
Sets the operating speed of the
Ethernet port (100M or 10M).
Shows Ethernet link status (auto-
negotiation, duplex, speed).
Saves Ethernet settings.
Ends the console or telnet session.
Displays the configuration of the flash
file system.
Shows the current partition.
Selects a partition as the current flash
file system.
Commands Introduction