Analog Input/Output Parameters For Extension Card; Ai1 Function Selection; Ai1 Analog Signal Mode; Max. Avi3 Input Voltage - Delta Electronics AC Motor Drive VFD-E User Manual

Chapter 4 Parameters|
Group 12: Analog Input/Output Parameters for Extension Card
Make sure that the extension card is installed on the AC motor drive correctly before using group 12
parameters. See Appendix B for details.

AI1 Function Selection

12.00
Settings

AI1 Analog Signal Mode

12.01
Settings
Besides parameters settings, the voltage/current mode should be used with the switch.
12.02 Min. AVI3 Input Voltage
Settings
12.03 Min. AVI3 Scale Percentage
Settings
12.04

Max. AVI3 Input Voltage

Settings
4-144
0 Disabled
1 Source of the 1st frequency
2 Source of the 2nd frequency
3 PID Set Point (PID enable)
4 Positive PID feedback
5 Negative PID feedback
0 ACI2 analog current (0.0 ~ 20.0mA)
1 AVI3 analog voltage (0.0 ~ 10.0V)
AVI3 AVI4
ACI2 ACI3
0.0 to 10.0V
0.0 to 100.0%
0.0 to 10.0V
AVO1 AVO2
ACO1 ACO2
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Factory Setting: 0
Factory Setting: 1
Unit: 0.1
Factory Setting: 0.0
Unit: 0.1
Factory Setting: 0.0
Unit: 0.1
Factory Setting: 10.0