Delta Electronics AC Motor Drive VFD-E User Manual page 63

Chapter 4 Parameters|
Parameter Explanation
03.02 Desired Frequency
1 Attained
Analog Output
03.03
Signal Selection
(AFM)
03.04 Analog Output Gain
03.05 Terminal Count
Value
Preliminary Count
03.06
Value
EF Active When
03.07 Terminal Count
Value Attained
03.08 Fan Control
4-10
Settings
8: Fault indication
9: Desired frequency 1 attained
10: Terminal count value attained
11: Preliminary count value attained
12: Over Voltage Stall supervision
13: Over Current Stall supervision
14: Heat sink overheat warning
15: Over Voltage supervision
16: PID supervision
17: Forward command
18: Reverse command
19: Zero speed output signal
20: Warning(FbE,Cexx, AoL2, AUE, SAvE)
21: Brake control (Desired frequency
attained)
22: Drive ready
23: Desired frequency 2 attained
0.00 to 600.0Hz
0: Analog frequency meter
1: Analog current meter
1 to 200%
0 to 9999
0 to 9999
0: Terminal count value attained, no EF
display
1: Terminal count value attained, EF active
0: Fan always ON
1: 1 minute after AC motor drive stops, fan
will be OFF
2: Fan ON when AC motor drive runs, fan
OFF when AC motor drive stops
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Factory
Customer
Setting
0.00
0
100
0
0
0
0