Delta Electronics AC Motor Drive VFD-E User Manual page 130

Settings Function
PID function
15
disabled
16 Output Shutoff Stop
Parameter lock
17
enable
Operation
Command
18 Selection (Pr.02.01
setting/external
terminals)
Operation
Command
19 Selection (Pr 02.01
setting/Digital
Keypad)
Operation
Command
20 Selection (Pr 02.01
setting/
Communication)
21 Forward/Reverse
Source of second
22 frequency
command enabled
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Description
When an input ON with this setting is ON, the PID function will be
disabled.
AC motor drive will stop output and the motor free run if one of
these settings is enabled. If the status of terminal is changed, AC
motor drive will restart from 0Hz.
When this setting is enabled, all parameters will be locked and
write parameters is disabled.
ON: Operation command via Ext. Terminals
OFF: Operation command via Pr.02.01 setting
When the settings 18, 19 and 20 are ON at the same time, the
priority should be setting 18 > setting19 > setting20.
ON: Operation command via Digital Keypad
OFF: Operation command via Pr.02.01 setting
When the settings 18, 19 and 20 are ON at the same time, the
priority should be setting 18 > setting19 > setting20.
ON: Operation command via Communication
OFF: Operation command via Pr.02.01 setting
When the settings 18, 19 and 20 are ON at the same time, the
priority should be setting 18 > setting19 > setting20.
This function has top priority to set the direction for running (If
"Pr.02.04=0")
Used to select the first/second frequency command source. Refer
to Pr.02.00 and 02.09.
nd
ON: 2 Frequency command source
st
OFF: 1 Frequency command source
Chapter 4 Parameters|
4-77