Group 3 Output Function Parameters; Group 4 Input Function Parameters - Delta Electronics VFD S 115V Series User Manual

Group 3 Output Function Parameters

Pr.
3-00 Analog Output Signal
3-01 Analog Output Gain
3-02 Desired Frequency Attained
3-03 Terminal Count Value
3-04 Preliminary Count Value
Multi-Function Output Terminal 1
3-05
(Photocoupler Output)
Multi-Function Output Terminal 2
3-06
(Relay Output)

Group 4 Input Function Parameters

Pr.
4-00 Potentiometer Bias Frequency
Potentiometer Bias
4-01
Polarity
Potentiometer
4-02
Frequency Gain
Potentiometer Reverse
4-03
Motion Enable
Revision August 2008, SE09, SW V2.61
Explanation
Explanation
Chapter 5 Parameters|VFD-S Series
Settings
d0: analog frequency meter
d1: analog current meter
d1 to d200%
d1.0 to d400 Hz
d0 to d999
d0 to d999
d0: No Function
d1: AC Drive Operational
d2: Master Frequency Attained
d3: Zero Speed
d4: Over Torque Detection
d5: Base-Block (B.B.) Indication
d6: Low-Voltage Indication
d7: Operation Mode Indication
d8: Fault Indication
d9: Desired Frequency Attained
d10: PLC Program Running
d11: PLC Program Step Completed
d12: PLC Program Completed
d13: PLC Program Operation
Paused
d14: Terminal Count Value Attained
d15: Preliminary Count Value
Attained
d16: AC Motor Drive Ready
d17: FWD command Indication
d18: REV command Indication
Settings
d 0.0 to d 100.0%
d0: Positive Bias
d1: Negative Bias
d1 to d200 %
d0: Forward Motion Only
d1: Reverse Motion enabled
Factory
NOTE
Setting
d0
d100
d1.0
d0
d0
d1
d8
Factory
NOTE
Setting
d0.0
d0
d100
d0
5-5