16-Bit Timer - Delta Electronics AC Motor Drive VFD-E User Manual

Appendix D How to Use PLC Function|
Explanations:
When the RST command is driven, motion of its specific device is as follows:
Program Example:
Ladder diagram:
X0
Mnemonic
TMR
Operand
Explanations:
When TMR command is executed, the specific coil of timer is ON and timer will start to count. When
the setting value of timer is attained (counting value >= setting value), the contact will be as following:
NO(Normally Open) contact
NC(Normally Closed) contact
Program Example:
Ladder diagram:
X0
TMR
D-38
Device
Y, M Coil and contact will be set to "OFF".
Present values of the timer or counter
T, C will be set to 0, and the coil and contact
will be set to "OFF."
D The content value will be set to 0.
RST
Y5
T-K T0~T15, K0~K32,767
T-D T0~T15, D0~D29
T5 K1000
Status
Command code: Operation:
LD X0
RST Y5
Function

16-bit timer

Open collector
Close collector
Command code: Operation:
LD X0 Load contact A of X0 T5 timer
TMR T5 K1000 Setting is K1000
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Load contact A of X0
Clear contact Y5