Chapter 7 Servo Parameters|ASDA-B Series
Group 8: P8-xx
Keypad Parameters
NOTE
All the keypad parameters cannot be download to PC or the servo drive via communication. Users only can
edit and change the keypad parameters through the keypad.
P8 - 00★
KVER
Keypad Firmware Version
Default: Factory setting
Applicable Control Mode: P/S/T
Unit: N/A
Range: N/A
P8 - 01
KFUN
Keypad Communication and Reset Setting
Default: 1
Applicable Control Mode: P/S/T
Unit: N/A
Range: 0 ~ 011
Settings:
ASD-PU-01A
ASD-PU-01B
• Communication Method Settings:
0: If 0 is set, it indicates the keypad is the slave side during communication. 0 must be set
when communicating with PC, or there will be a communication fault.
7-68
Communication Addr.: 0800H
Related Section: N/A
Communication Addr.: 0801H
Related Section: N/A
Revision January, 2009