Output Setting For Frequency Division (Denominator); Pg Electrical Gear A (Channel 1 Of Pg Card); Pg Electrical Gear B (Channel 2 Of Pg Card); Pg Position Control Point (Home) - Delta Electronics AC Motor Drive VFD-VE Series User Manual

Chapter 4 Parameters|
10-16

Output Setting for Frequency Division (denominator)

Control
VFPG FOCPG TQRPG
mode
Settings
This parameter is used to set the denominator for frequency division. For example, when it is
set to 2 with feedback 1024ppr, PG output will be 1024/2=512ppr.
10-17

PG Electrical Gear A (Channel 1 of PG card)

Control
VFPG FOCPG
mode
Settings
10-18

PG Electrical Gear B (Channel 2 of PG card)

Control
VFPG FOCPG
mode
Settings
Rotation speed = pulse frequency/encoder pulse (Pr.10-00) * PG Electrical Gear A / PG
Electrical Gear B.
10-19

PG Position Control Point (Home)

Control
VFPG FOCPG
mode
Settings
This parameter determines the home position in the position control.
4-154
Phase A is a pulse input and phase B is a direction input. (low
input=forward direction, high input=reverse direction)
FWD
4
A
B
1 to 255
1 to 5000
1 to 5000
0 to 20000
REV
Factory Setting: 1
Factory Setting: 100
Factory Setting: 100
Factory Setting: 0
Revision August 2008, 03VE, SW V2.04
Unit: 1
Unit: 1
Unit: 1
Unit: 1