Torque Command; Torque Command Source; Maximum Torque Command; Filter Time Of Torque Command - Delta Electronics AC Motor Drive VFD-VE Series User Manual

07-20

Torque Command

Control
TQRPG
mode
Settings
This parameter is torque command. When Pr.07-22 is 250% and Pr.07-20 is 100%, the actual
torque command = 250%X100% X motor rated torque.
07-21

Torque Command Source

Control
TQRPG
mode
Settings
This parameter is torque command source and the torque command is in Pr.07-20.
07-22

Maximum Torque Command

Control
TQRPG
mode
Settings
This parameter is for the max. torque command (motor rated torque is 100%).
07-23

Filter Time of Torque Command

Control
TQRPG
mode
Settings
When the setting is too long, the control will be stable but the control response will be delay.
When the setting is too short, the response will be quickly but the control maybe unstable.
User can adjust the setting by the control and response situation.
07-24 Speed Limit Selection
Control
TQRPG
mode
Settings
Revision August 2008, 03VE, SW V2.04
-100.0 to 100.0%
(Pr. 07-22 setting=100%)
0 Digital keypad
1 RS485 serial communication (RJ-11)
2 Analog signal (Pr.03-00)
0 to 500%
0.000 to 1.000 sec
0 By Pr.07-25 and Pr.07-26
1 Frequency command source (Pr.00-20)
Chapter 4 Parameters|
Factory Setting: 0.0
Factory Setting: 0
Factory Setting: 100
Factory Setting: 0.000
Factory Setting: 0
Unit: 0.1
Unit: 1
Unit: 0.001
4-115