Terminals Descriptions; Wiring Notes; B.8 Pg Card (For Encoder); B.8.1 Emv-Pg01X - Delta Electronics AC Motor Drive VFD-VE Series User Manual

Appendix B Accessories|

B.8 PG Card (for Encoder)

B.8.1 EMV-PG01X

AB2:
PG2 signal
mode switch
ABZ1:
PG1 signal
mode switch

1. Terminals descriptions

Terminal Symbols
VP
DCM
A1, A1
B1, B1
Z1, Z1
A2, A2
B2, B2

2. Wiring Notes

a.
b.
3. Wire length (wire length and signal frequency are in inverse proportion)
B-18
PG1
Pulse feedback
Power source of EMV-PG01X (use PS1 to switch 12V/5V)
Output Voltage: +5V/+12V±5% 200mA
Power source and input signal common
Input signal. Input type is selected by ABZ1. It can be 1-phase or 2-
phase input. Maximum 300kP/sec
Input signal. Input type is selected by AB2. It can be 1-phase or 2-
phase input. Maximum 300kP/sec
Grounding
Please use a shielded cable to prevent interference. Do not run control wires
parallel to any high voltage AC power line (200 V and above).
Recommended wire size 0.21 to 0.81mm
PS1:
5/12V switch
PG2
Pulse input
Descriptions
2
(AWG24 to AWG18).
Revision August 2008, 03VE, SW V2.04