Load And Use Config; Save Config Remotely; System Utilization; Selftest Run - ADTRAN ATLAS 800 PLUS User Manual

»» Load and Use
Config
»» Save Config
Remotely
» System Utilization
» System Selftest
»» Selftest Run
»» Status
»» View Selftest Log
61200226L1-1
Write security: 3; Read security: 5
Retrieves the configuration file specified in the
from the server. To start this command, enter
If you execute this command, the ATLAS 800
configuration file, reboots, then restarts using the new configuration.
Write security: 3; Read security: 5
Saves the configuration file specified in TFTP Server Filename to the
server identified in TFTP Server IP Address . To start this command, enter
to begin or enter to cancel.
Y N
Before using this command, you must have identified a valid TFTP
server in TFTP Server IP Address .
Write security: 0; Read security: 0
Displays statistics related to the ATLAS internal operating system. Please
check with ADTRAN Technical Support before attempting to use this
menu.
Write security: 3; Read security: 5
Initiates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
Self-tests disrupt data flow.
Write security: 3; Read security: 5
Activates the self-test. To confirm self-test activation, press
self-test press .
n
Security level: 3; Read security 5
Indicates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
Read security: 5
Displays time-stamped log of the tests conducted and the Pass/Fail results.
Self-tests verify data integrity and processor control to each port. Each port
is looped back and a data pattern is sent and tested.
The result of the self-test on each installed port is listed with Pass/Fail re-
sults. A typical test log is shown in Figure 6-5. The log includes the following
additional fields.
PLUS
ATLAS 800
Chapter 6. Terminal Menu and System Control
TFTP Server Filename
to begin or enter
Y
User Manual
field
to cancel.
N
PLUS
retrieves the
y ; to cancel the
6-17