Table of Contents
Advertisement
»» Port Type
»» Port Speed
»» Modem
Initialization String
»» Initialize Modem
»» Flow Control
» SNMP
»» SNMP Access
»» SNMP Communities Write security: 3; Read security: 5
»» Trap Transmission
»» Authen Trap
Transmission
61200226L1-1
Write security: 2; Read security: 5
Specifies whether you use
Write security: 2; Read security: 5
Specifies the baud rate of the port. Select either 2400, 9600, 19200, or 38400.
If you are using
for Port Type , ensure that the Port Speed setting
Dial
matches the modem baud rate.
Write security: 2; Read security: 5
Specifies the initialization string for a modem. Refer to your modem docu-
mentation for acceptable initialization strings.
Write security: 4; Read security: 5
Sends the Modem Initialization string to the modem. When you select this
command, the following message displays:
nected to the chain port before continuing. Confirm (y/n).
modem is connected before selecting
Write security: 2; Read security: 5
This option sets the flow control for the chain port. You may configure the
chain port flow control for OFF or H/W (hardware).
Write security: 3; Read security: 5
Provides a way to configure SNMP access for the ATLAS 800
detailed information on SNMP, refer to SNMP Management on page 12-1.
The following options are available for review and editing:
Write security: 3; Read security: 5
Defines whether SNMP access to the ATLAS 800
Select the appropriate option.
Defines SNMP manager(s) characteristics as follows:
IP Address
Specifies the IP address of the network manager.
Privileges
Defines Get (read-only) and Get/Set (read and write) privi-
leges.
Get Name
Defines the community name for Get access. This value
must match the Get name defined on the network manage-
ment station. Public is the default name.
Set Name
Defines the community name for Set access. This value must
match either the Get or Set name defined on the network
management station. Public is the default name.
Write security: 3; Read security: 5
Enables and disables SNMP trap transmission.
Write security: 3; Read security: 5
Enables and disables the authentication failure trap.
PLUS
ATLAS 800
Chapter 6. Terminal Menu and System Control
Direct
or
Dial
mode.
Please verify a modem is con-
.
Y
PLUS
User Manual
Ensure that a
PLUS
. For
is enabled or disabled.
6-9
Advertisement
Table of Contents
