Table of Contents
Advertisement
Chapter 10. Dial Plan Terminal Menu
» In#Accept
»» Source ID
»» Accept Numbers
»» Search
10-6
Write security: 3; Read security: 5
This submenu defines the parameters for incoming calls that
PLUS
ATLAS 800
will accept from the Network.
Write Security: 3 Read Security: 5
This field identifies the ID of the call sources that this endpoint will accept
calls from. The Source ID field is used to simplify the creation of a Dial Plan
in applications where the criteria for switching calls to a certain endpoint is
a function of which endpoint originated the call.
Source ID may be entered with the usual wild card entries (except $)
X = any digit 0—9
[1,3,5] = any of these digits
Default value = 0. The default ID for all Source endpoint is 0 and all accept
#'s is 0. This results in all calls being routed based on the dialed number.
Write security: 3; Read security: 5
This field designates which numbers this end point will accept (terminate)
from the Network (PSTN). The accept list may consist of multiple entries.
The numbers are defined using "wild cards":
X = Any single digit
N = Any single digit 2—9
$ = Any number of digits of any value
9 = This specific number
[1,2,3...] = A single digit in this group
For example, 963-8000 would be a specific incoming number that would be
accepted by this end point. If this end point consisted of a T1 with multiple
DS0s, a "hunt" group for 963-8000 would be formed. The entry $ would ac-
cept any call.
Any specific entry will take precedence over a wild card. For
example, if end point "A" was designated as $ while end point "B"
accepted 963-800X, then an incoming call to 963-800X would only
be accepted by end point "B."
Write Security: 3 Read Security: 5
Defines to ATLAS the order in which to search for an Accept Number.
PLUS
ATLAS 800
User Manual
61200226L1-1
Advertisement
Table of Contents
