S1-S8; Util; Time/Date; Software Rev - ADTRAN ATLAS 800 PLUS User Manual

» S1—S8

UTIL

>
» Time/Date
» Software Rev
61200226L1-1
Unit ID Accesses the current Unit ID setting, which is the system
identifier used for ADTRAN Data Link Layer Protocol
(ADLP) configuration control (such as using T-Watch
PRO).
Editing or changing the Unit ID requires the use of a
passcode if a passcode is defined. See Set Passcode on
page 4-11 for details on working with passcodes. Unit
Identification numbers must be between 2 and 9999. The
number 1 is reserved for the PC.
Press Enter to record the Unit ID number and establish
its availability when operating by remote control. Press
Cancel at any time to end the editing process.
Init Modem Provides the option to send the modem initialization
string (e.g., ATE0V1&D2S0=1) from the chain port to a
modem connected to the chain port. Configure this
string in the terminal menus. See Modem Initialization
String on page 6-9 for details on how to change this field.
The Init Modem option is only used if Type is set to Dial.
Displays the current configuration options of installed modules. S1 corre-
sponds to slot 1, S2 to slot 2, and so on. When you select one of these options,
you can enable or disable the selected module. The current status, ENA (En-
abled) or DIS (Disabled), displays next to the module name. Set this field to
DIS (Disable) prior to removing a module from the ATLAS 800
The Utility menu allows miscellaneous settings to be displayed or modified.
Displays and/or edits the current time and date. The ATLAS 800
tains the time and date during power off conditions.
After any numeric change, press Enter to record the entry and move to the
next editing position. You can also move to a different field to edit by press-
ing Enter at the editing position without making any change, or by using the
up and down arrow keys. Press Cancel at any time to end the editing pro-
cess.
Displays the current software revision level loaded into the Base Unit con-
troller. This information is required when requesting assistance from ADT-
RAN Technical Support or when updates are needed. Press Cancel to exit
this option.
PLUS
ATLAS 800
Chapter 4. Using the Front Panel
User Manual
PLUS
unit.
PLUS
main-
4-9