Ethernet 10BaseT Connection
Connection
MON
Option Slots
61200226L1-1
The 10BaseT Ethernet port (RJ-48C) provides an Ethernet LAN connection,
which is used for TFTP, SNMP, and Telnet connection.
The network connection follows, with the pinout shown in Table 2-4.
Connector type (USOC)
Part number
The MON (monitor) test jack provides a bridged access jack for non-intru-
sive monitoring of the T1 circuits receiving data. When connected to this
jack, the test equipment should be configured for a bridged termination.
Figure 2-3 shows the option slot numbering designation, as viewed from the
PLUS
rear of the ATLAS 800
seven and eight, which can also accommodate an optional power supply for
redundancy.
PLUS
ATLAS 800
Chapter 2. Installing the ATLAS 800PLUS
RJ-48C
AMP# 555164-2
Table 2-4. Ethernet 10BaseT Pinout
PIN
NAME
1
TX1
2
TX2
3
RX1
4 & 5
UNUSED —
6
RX2
7 & 8
UNUSED —
. All slots are functionally identical except slots
User Manual
DESCRIPTION
Transmit Positive
Transmit Negative
Receive Positive
Receive Negative
2-7