Table of Contents
Advertisement
Chapter 10. Dial Plan Terminal Menu
OCTAL BRI MODULE (USER TERMINATION)
»» Switch Type
»» SPID List
»» Strip MSD
»» Source ID
»» Outgoing Caller ID
10-20
The Octal BRI with a "U" interface acts as the Network while interfacing to
user equipment (terminal adapters). When you are working in the Network
Termination section of the Dial Plan menu and the Slot is defined as a
UBRI-8 module, the following interface configuration options are available:
Write security: 2; Read security: 5
Defines the type of ISDN switch that ATLAS will simulate. If connected to
another ATLAS, both need to be set to the same type. The available options
include Lucent 5E, Northern DMS 100, and National ISDN.
Write security: 2; Read security: 5
ATLAS, acting as the Network, must use a SPID and a phone number in or-
der to satisfy the ISDN connection protocol expected by the User's Terminal
Adapter (TA).
Phone Number The phone number(s) assigned to this BRI phone line.
SPID Number
This entry will define the SPID number(s) which will be
used for this BRI line. Although the value of the SPID is
not significant, a SPID must be entered for each phone
number. For convenience, the SPID can be set to be the
same as the phone number.
ATLAS 800
which some terminal adapters offer.
Calls
For User terminations, the number of calls is fixed at 2.
D64, D56,
These options reflect what the Network has provisioned
Audio, Speech
for this SPID. If the BRI was purchased with different ser-
vices provisioned for the SPIDs, then the call must match
the services supported.
This option allows a selected quantity of the Most Significant digits of a di-
aled number for ATLAS to be stripped prior to being forwarded out of the
port. Note that the Strip MSD parameter does not affect the Call Accept cri-
teria. All of the digits (including the MSDs that are subsequently stripped)
are used as accept criteria.
Source ID for the incoming calls.
Specifies how caller ID information is sent to the user BRI device.
Send as
Send caller ID information as provided by the user BRI de-
provided
vice.
Substitute if
If no caller ID information is provided by the user BRI de-
not present
vice, substitute with ID Presentation and ID Number .
Substitute
Ignore caller ID information is provided by the user BRI
always
device, and substitute with ID Presentation and
ber .
PLUS
ATLAS 800
PLUS
does not support autoSPID detection software
User Manual
D Num-
I
61200226L1-1
Advertisement
Table of Contents
