Advertisement
Quick Links
Advertisement
Related Manuals for ADTRAN SMART/RG SR360n
Summary of Contents for ADTRAN SMART/RG SR360n
- Page 1 SR360n Quick Start Guide...
-
Page 2: Installation
Installation Connect one end of the supplied DSL cable to the port labeled DSL on the gateway and connect the other end t the DSL wall jack installed by your provider. For all other devices, connect an Ethernet cable from that device to any of the LAN ports on the gateway. - Page 3 5 min...
-
Page 4: Led Indicators
LED Indicators The LEDs on the front of the SR360n can assist you in better understanding the current state of your gateway. POWER LAN 1-4 WLAN INTERNET DSL sync in progress DSL sync acquired and gateway online Gateway online and data transfer in progress IP connection failure WiFi enabled on modem PC / network activity / data transfer... - Page 5 Quick Gateway Configuration Warning: Do not press the Reset button unless you want to clear the current settings. The Reset button is in a small circular hole on the rear panel. If you want to restore the default settings, insert a thin wire (such as a paper clip) into the hole, press gently for 1 second, and then release the button.
- Page 6 Note: Your service provider may use other settings. Please contact your provider for login information. Configuring the WAN manually If the automatic connect process is unsuccessful, refer to the Advanced Setup > Layer 2 Interface WAN Services sections of the SmartRG SR360n Gateway User Manual to manu- ally establish a connection.
- Page 7 WiFi Setup Two methods, WPS and Manual, are available for WiFi setup. Perform the steps on this page for both methods, and then follow the instructions for the method you desire. In the left navigation bar, click Wireless >Basic. If not already selected, click Enable Wireless.
- Page 8 WPS Method If the device you want to connect to the Internet via your SmartRG gateway supports the WPS secure WiFi connection method, you may follow these steps. 1. In the left navigation bar, click Wireless > Security. 2. If the Enable WPS field is not already set to Enabled, select it now.
- Page 9 5. Within 2 minutes, activate on the 3rd party device to which you wish to connect. It may have a pushbutton on its exterior or a software interface is used to initiate connection. To learn how to use the WPS feature on your client device, refer to its documentation.
- Page 10 Manual Method Set up your gateway’s parameters first, then follow these steps. 1. In the left navigation bar, select Wireless > Security and scroll down to the Manual Setup AP section. 2. If your gateway supports multiple wireless networks, select the SSID of the network you wish to configure.
- Page 11 4. Choose a WPA Passphrase and type it in this field. You will need this passphrase for step 7. 5. Select any desired encryption preferences in the lower three fields. 6. Click Apply / Save. 7. Follow the WiFi connection instructions provided with your client device to connect to the router.
-
Page 12: Optional Wall Mount
Optional Wall Mount Using a Phillips-head screwdriver, remove the mount from its present location on the bottom of the gateway. Slide the mount onto the back of the gateway. Tighten the screw located in the bottom of the Gateway mount. Front Using the template below, mount the two included screws to the wall. -
Page 13: Additional Support
Preset wireless settings on your If you change the preset wireless router settings WiFi network name (SSID) Network key (pass- word) Additional Support If you require further instructions, please contact your local ISP Support. SmartRG Inc. an ADTRAN company. All Rights Reserved. © 2020...