Tcid Timer; Call Stagger; System Utility; Update Firmware - ADTRAN ATLAS 800 PLUS User Manual

»» TCID Timer
»» Call Stagger
Display value
No Stagger
There is no delay between the call dialing of a BONDING session.
500 ms Wait approximately ½ second between the call dialing of a BONDING session.
1 sec
Wait approximately 1 second between the call dialing of a BONDING session.
2 sec
Wait approximately 2 seconds between the call dialing of a BONDING session.
SYSTEM
>
UTILITY
» Update Firmware
61200226L1-1
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to negotiate an agree-
able value for bearer channels and channel capacities before deciding the
BONDING call has failed.
Write security: 3; Read security: 5
Specifies the amount of delay between placing calls for outgoing BOND-
ING sessions. Table 6-2 defines the call stagger values.
Use the System Utility menu to view and set the system parameters shown
in Figure 6-4.
Write security: 1; Read security: 5
Updates firmware when ATLAS 800
transfer methods are available for use in updating any modules that contain
Flash memory—including the ATLAS system controller.
The first transfer method uses the ATLAS serial Chain-In port of the system
controller and XMODEM protocol. For detailed information on how to up-
date firmware using this method, see XMODEM Firmware Updates on page
11-1.
The second transfer method uses the ATLAS built-in Ethernet port of the
system controller and TFTP (Trivial File Transfer Protocol). For detailed in-
PLUS
ATLAS 800
Chapter 6. Terminal Menu and System Control

Table 6-2. Call Stagger Values

Meaning

Figure 6-4. System Utility Menu

PLUS
enhancements are released. Two
User Manual 6-13